Differences

This shows you the differences between two versions of the page.

--- wiki:20_rdc_charger:35_commissioning:06_ev_fleet [2024/12/10 08:30] – alen.mejak
+++ wiki:20_rdc_charger:35_commissioning:06_ev_fleet [2025/03/21 13:07] (current) – saso.santelj
@@ Line 10: / Line 10: @@
 :!: Only one RDC charger is master in ev fleet !
-=== Procedure to set RDX Charger as slave is as follows: ===
+=== Procedure to set RDC Charger as slave is as follows: ===
   * [[wiki:20_rdc_charger:30_software:start#evse_overview|RDC Charger]] -> set Max current (1)
   * RDC Charger -> enable "EVSE works as slave" (2) Master SN presents serial number of master charger, it will appear once connection is established.
@@ Line 28: / Line 28: @@
   * (5) select limiter priority for chargers: no limiter, limit last (last to be limited), limit second, limit first (first to be limited)
 {{wiki:20_rdc_charger:hems_config_cluster_04.png?direct&800|}}
-  * HEMS Configurator -> IO mux -> enter IP address of slave RDX Charger (6). Serial number (SN) will be listed automatically once connection is established.
+  * HEMS Configurator -> IO mux -> enter IP address of slave RDC Charger (6). Serial number (SN) will be listed automatically once connection is established.
 {{wiki:20_rdc_charger:hems_config_cluster_05.png?direct&800|}}
   * HEMS Configurator -> ev fleet:\\ (7) master RDC Charger,\\ (8) connected slave RDC Charger with enabled control by master (green tick) and\\ (9) connected slave RDC Charger with disabled control (red X) -> master can not control it! To enable control, run RDC Charger app on slave charger and enable "EVSE works as slave".
 {{wiki:20_rdc_charger:hems_config_cluster_06.png?direct&800|}}\\