Differences

This shows you the differences between two versions of the page.

--- wiki:20_rdc_charger:35_commissioning:05_dlm [2024/08/26 15:07] – saso.santelj
+++ wiki:20_rdc_charger:35_commissioning:05_dlm [2024/08/26 15:07] (current) – saso.santelj
@@ Line 9: / Line 9: @@
 Procedure to activate Dynamic Load Management is as follows:
   * [[wiki:20_rdc_charger:30_software:start#hems_configurator|HEMS Configurator]] -> settings -> Virtual grid PS must be disabled (1)
-  * Wire [[wiki:20_rdc_charger:15_hardware:20_pm1-ct|PM1-E-D-CT,]] [[wiki:20_rdc_charger:15_hardware:21_pm3|PM3-E-D]] or [[wiki:20_rdc_charger:15_hardware:21_pm3-CT|PM3-E-D-CT]]to [[wiki:20_rdc_charger:25_wiring:start#wireless_power_sensors_wiring|WM-1]] module (use default address 149 or manually set address to 150)
+  * Wire [[wiki:20_rdc_charger:15_hardware:20_pm1-ct|PM1-E-D-CT,]] [[wiki:20_rdc_charger:15_hardware:21_pm3|PM3-E-D]] or [[wiki:20_rdc_charger:15_hardware:21_pm3-CT|PM3-E-D-CT]] to [[wiki:20_rdc_charger:25_wiring:start#wireless_power_sensors_wiring|WM-1]] module (use default address 149 or manually set address to 150)
   * HEMS Configurator -> settings -> select WM/WR pairing button and follow [[wiki:20_rdc_charger:35_commissioning:03_wr_wm|WM/WR pairing instructions]] (2) (3)
 {{wiki:20_rdc_charger:hems_config_dynamic_01.png?direct&800|}}