Differences

This shows you the differences between two versions of the page.

--- wiki:20_rdc_charger:20_mounting:start [2023/05/26 13:04] – external edit 127.0.0.1
+++ wiki:20_rdc_charger:20_mounting:start [2024/01/17 13:36] (current) – alen.mejak
@@ Line 13: / Line 13: @@
 REQUIRED EQUIPMENT:
   * Impact hammer and concrete drill ф 8mm
-  * Phillips screwdriver PH2 - Screws for fixing the mounting plate to the wall, screws for mounting the charger to the mounting plate
+  * Phillips screwdriver PH2 - Screws for fixing the mounting plate to the wall
   * SL4 flat screwdriver – Screwing power cables (model without Residual-current device)
   * Phillips screwdriver PZ2 - Screwing the power cables on the RCD (model with Residual-current device)
   * Allen key 2.5mm (included) - For screws of the plastic cover and for switching the RCD(for models with it)
+  * Allen key 3mm - For mounting screws the charger to the mounting plate
   * Pliers for crimping cable glands and shoes
   * Pliers and tools for removing insulation from cables and wires
- **Lean the mounting plate against the wall and mark all 4 holes. Help yourself with the included water level.**
+ **Lean the mounting plate against the wall and mark all 4 holes. Help yourself with the  water level.**
 {{wiki:20_rdc_charger:montaza_1.png}}\\
@@ Line 32: / Line 33: @@
 {{wiki:20_rdc_charger:montaza_3.png}}\\
-**Open the cover and put it down. Thread the power supply and ethernet cable through the rubber plugs. Place the RDC Charger against the mounting plate and screw in all four M5 side screws. (Phillips screwdriver PH2)**
+**Open the cover and put it down. Thread the power supply and ethernet cable through the rubber plugs. Place the RDC Charger against the mounting plate and screw in all four M5 side screws. (Allen key 3mm)**
 {{wiki:20_rdc_charger:montaza_4.png}}\\