1-ph current transformer []

This page is read only. You can view the source, but not change it. Ask your administrator if you think this is wrong.
====== 1-ph current transformer ======

**Split core current transformer 50A **

<WRAP column 350px>

{{ wiki:20_rdc_charger:03_hardware:ct_main_picture.png |}}

</WRAP>

<WRAP column 300px>

| Model number: ^ CT1-E-50                                           |
| Connect to:   | [[wiki:20_rdc_charger:15_hardware:20_pm1-ct]]       |
| :::           | terminals 1 -2                                      |
| Mounting:     | on wire                                             |
| Dimensions:   | 41 × 24 × 27 mm                                     | 

</WRAP>

<WRAP clear></WRAP>

  * Split core
  * Safe operation
  * Mini in size
  * Very easy mounting
  * Wide inner window

===== General description =====

The CT1-E-50 split core current transformer is designed for fast and easy installation. The split core design permits non-contact current measurements through magnetic field induction without requiring that the primary wire be taken off line and disconnected for CT installation. This method permits a safer easy and portable current measurement. An internal precision burden resistor across the secondary winding of the CT provides a safe low voltage output and permits safe opening of the secondary circuit.

<WRAP pagebreak></WRAP>

===== Technical specifications =====

|< 50% 50% >|
| Frequency                 |                                      50-60 Hz |
| Rated current             |                                          50 A |
| Accuracy                  |         ±1% from 20% to 120% of rated current |
| Phase angle               |   less than 2 degrees at 50% of rated current |
| Insulation voltage        |                                       600 VAC |
| Maximum primary voltage   |                5000 VAC (insulated conductor) |
| Dielectric strength       |                               2.5 kV/1mA/1min |
| Operating temperature     |                                   -15 to 60°C |
| Operating humidity        |                                        < 85 % |
| Case material             |                                    PC/UL94-V0 |
| Bobin                     |                                           PBT |
| Core                      |                                     Permalloy |
| Internal structure        |                                         Epoxy |
| Leads                     |                 UL 1015, Twisted pair, 22 AWG |