Temperature and humidity monitoring []

This page is read only. You can view the source, but not change it. Ask your administrator if you think this is wrong.
====== Temperature and humidity monitoring ======

The system is intended for monitoring temperatures and relative humidity in rack cabinets of data centers. Allows connection of up to 120 sensors to one controller. The number of controllers per system is practically unlimited.

===== HW and wiring =====

{{:wiki:01_btms:00_th_monitoring:temperature_monitoring_wiring_v1.png?nolink|}}

===== SW (TH-MC & Configurator) =====


==== Main page ====

<WRAP group>
<WRAP 1000px column>
{{:wiki:01_btms:00_th_monitoring:main.png?nolink|}}
</WRAP>

<WRAP column>
|<300px 50px >|
^  1  | New sensor                                                                                                                              |
^  2  | Sensor table - Select empty single cell to Assign new sensor to cell or select assigned cer to un-assign (only if new sensor is empty)  |
^  3  | Statistics of all sensors.                                                                                                              |
</WRAP>
</WRAP>


<WRAP group>
<WRAP 620px column>
{{:wiki:01_btms:00_th_monitoring:main_assign.png?nolink|}}
</WRAP>

<WRAP column>
Press [Assign] to assign new sensor to selected cell 001.
</WRAP>
</WRAP>

<WRAP group>
<WRAP 620px column>
{{:wiki:01_btms:00_th_monitoring:main_unassign.png?nolink|}}
</WRAP>

<WRAP column>
Press [Unassign] to move selected sensor 001 to New sensor.
</WRAP>
</WRAP>

<WRAP group>
<WRAP 620px column>
{{:wiki:01_btms:00_th_monitoring:main_clear_alarm.png?nolink|}}
</WRAP>

<WRAP column>
Press [Clear Alarms] to clear alarms from selected cell. 

Multiple cells can be selected.
</WRAP>
</WRAP>

<WRAP group>
<WRAP 620px column>
{{:wiki:01_btms:00_th_monitoring:main_clear_error.png?nolink|}}
</WRAP>

<WRAP column>
Press [Clear error] to clear errors from selected cell. 

Multiple cells can be selected.
</WRAP>
</WRAP>

==== Events list ====

MC put all events (sensors move and alarms) in FIFO list (100 events in total). On Configurator page Events last 25 events are shown.

<WRAP group>
<WRAP 1000px column>
{{:wiki:01_btms:00_th_monitoring:events.png?nolink|}}
</WRAP>

<WRAP column>

</WRAP>
</WRAP>

==== System ====

System overview and settings.

<WRAP group>
<WRAP 1000px column>
{{:wiki:01_btms:00_th_monitoring:system.png?nolink|}}
</WRAP>

<WRAP column>
|<300px 50px >|
^  1  | System settings:\\ - MC serial number\\ - SW version\\ - MC Kernel version\\ - MC IP    |
^  2  | MC RTC\\ Important for event logger                                                     |
^  3  | Permanent memory management: \\ Alarm settings are stored to permanent (EEPROM) memory  |
^  4  | Alarm settings\\ Set to 0 to disable alarm or alarm clear functionality.                |
</WRAP>
</WRAP>