wiki:20_rdc_charger:20_mounting:start
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionLast revisionBoth sides next revision | ||
wiki:20_rdc_charger:20_mounting:start [2023/04/07 11:01] – alen.mejak | wiki:20_rdc_charger:20_mounting:start [2024/01/17 13:27] – alen.mejak | ||
---|---|---|---|
Line 13: | Line 13: | ||
REQUIRED EQUIPMENT: | REQUIRED EQUIPMENT: | ||
* Impact hammer and concrete drill ф 8mm | * Impact hammer and concrete drill ф 8mm | ||
- | * Phillips screwdriver PH2 - Screws for fixing the mounting plate to the wall, screws for mounting the charger to the mounting plate | + | * Phillips screwdriver PH2 - Screws for fixing the mounting plate to the wall |
* SL4 flat screwdriver – Screwing power cables (model without Residual-current device) | * SL4 flat screwdriver – Screwing power cables (model without Residual-current device) | ||
* Phillips screwdriver PZ2 - Screwing the power cables on the RCD (model with Residual-current device) | * Phillips screwdriver PZ2 - Screwing the power cables on the RCD (model with Residual-current device) | ||
* Allen key 2.5mm (included) - For screws of the plastic cover and for switching the RCD(for models with it) | * Allen key 2.5mm (included) - For screws of the plastic cover and for switching the RCD(for models with it) | ||
+ | * Allen key 3mm - For mounting screws the charger to the mounting plate | ||
* Pliers for crimping cable glands and shoes | * Pliers for crimping cable glands and shoes | ||
* Pliers and tools for removing insulation from cables and wires | * Pliers and tools for removing insulation from cables and wires | ||
- | | + | |
{{wiki: | {{wiki: | ||
Line 40: | Line 41: | ||
**Depending on the power of the charger, choose the appropriate cross-section of the power supply cable and the appropriate fuse. The connection terminals in the charger enable the connection of a cable up to 10mm2. If you have a charger model without a RCD switch, you must install it before the power supply cable.** | **Depending on the power of the charger, choose the appropriate cross-section of the power supply cable and the appropriate fuse. The connection terminals in the charger enable the connection of a cable up to 10mm2. If you have a charger model without a RCD switch, you must install it before the power supply cable.** | ||
- | {{wiki: | + | {{wiki: |
{{wiki: | {{wiki: | ||
wiki/20_rdc_charger/20_mounting/start.txt · Last modified: 2024/01/17 13:36 by alen.mejak