Differences

This shows you the differences between two versions of the page.

--- wiki:20_rdc_charger:35_commissioning:05_dlm [2023/03/31 10:07] – ↷ Page moved from wiki:20_rdc_charger:07_commissioning:05_dlm to wiki:20_rdc_charger:35_commissioning:05_dlm saso.santelj
+++ wiki:20_rdc_charger:35_commissioning:05_dlm [2023/03/31 10:12] – ↷ Links adapted because of a move operation saso.santelj
@@ Line 8: / Line 8: @@
 Procedure to activate Dynamic Load Management is as follows:
-  * [[wiki:20_rdc_charger:06_software:start#hems_configurator|HEMS Configurator]] -> settings -> Virtual grid PS must be disabled (1)
+  * [[wiki:20_rdc_charger:30_software:start#hems_configurator|HEMS Configurator]] -> settings -> Virtual grid PS must be disabled (1)
-  * Wire [[wiki:20_rdc_charger:03_hardware:20_pm1|PM1-E-D]] or [[wiki:20_rdc_charger:03_hardware:21_pm3|PM3-E-D]] to [[wiki:20_rdc_charger:05_wiring:start#wireless_power_sensors_wiring|WM-1]] module
+  * Wire [[wiki:20_rdc_charger:15_hardware:20_pm1|PM1-E-D]] or [[wiki:20_rdc_charger:15_hardware:21_pm3|PM3-E-D]] to [[wiki:20_rdc_charger:25_wiring:start#wireless_power_sensors_wiring|WM-1]] module
-  * HEMS Configurator -> settings -> select WM/WR binding button and follow [[wiki:20_rdc_charger:07_commissioning:03_wr_wm|WM/WR binding instructions]] (2) (3)
+  * HEMS Configurator -> settings -> select WM/WR binding button and follow [[wiki:20_rdc_charger:35_commissioning:03_wr_wm|WM/WR binding instructions]] (2) (3)
 {{wiki:rdx_charger:hems_config_dynamic_01.png?direct&800|}}
   * Power sensor is detected. Add it to grid position (4)